When working with a chainsaw, it may be necessary to take a link out of the chain to adjust the length or replace a damaged link. Removing a link from a chainsaw chain can seem daunting, but it is a simple process that can be done in just a few steps.

Tools Requirement:

You will need a few essential tools to tension a chainsaw chain properly. These include:

• Adjustable wrench
• Flathead screwdriver
• Chainsaw file
• Breaker tool (if the chain is too tight)

Precautions:

• Always wear protective gear such as safety glasses, ear protection, and heavy-duty gloves.
• Make sure the chainsaw is turned off and the chain has stopped moving before making any adjustments.
• Carefully follow the instructions provided in the chainsaw manual.

How to Get a Link Out of a Chainsaw Chain in 3 Simple Steps?

Remove the chainsaw bar cover: Before you begin, ensure the chainsaw is turned off and the chain has stopped moving. Then, remove the bar cover by releasing the latches or screws holding it.

Use an adjustable wrench to loosen the bar nut: Locate the bar nut, which is typically located near the bottom of the chainsaw bar. Use an adjustable wrench to loosen the bar nut, being careful not to over-tighten it.

Use a flathead screwdriver to push the link pin out of the chain:

1. Once the bar nut is loosened, use a flathead screwdriver to make the link pin out of the chain.
2. Push the pin out from the inside of the chain, as moving it from the outside can cause it to bend or break.
3. Repeat the process until the desired number of links are removed.

It’s important to note that, depending on the chainsaw model, the process may vary, so it’s always best to consult the user manual and follow the instructions provided by the manufacturer.

DIY Chainsaw breaker:

If the chain is too tight, you can use a breaker tool to loosen it. A DIY option is to use a vise or clamp to hold the chain in place while you use a flathead screwdriver to push out the link pin.

Frequently Asked Questions:

How often should I adjust the tension on my chainsaw chain?

Answer: The tension on your chainsaw chain should be regularly adjusted, usually after every 10 hours of use or when you notice the chain is loose.

Can a loose chainsaw chain cause damage to the chainsaw?

Answer: Yes, a loose chainsaw chain can cause damage to the chainsaw. It can cause increased vibration, wear on the guide bar and chain, and even damage the engine.

How tight should a chainsaw chain be?

Answer: A chainsaw chain should have just enough slack to move freely around the guide bar. Typically, a slack of about 1/8 inch is considered ideal.

Can I use a chainsaw file to sharpen the chain?

Answer: You can use a chainsaw file to sharpen the chain. Use the file to sharpen each tooth of the chain, carefully maintaining the same angle on each tooth.

Is it okay to sharpen the chainsaw?

Answer: Yes, it’s okay to sharpen the chainsaw. Sharpening the chain is an essential part of maintaining your chainsaw, and it can help to ensure that it is cutting efficiently and safely.

Conclusion:

Properly tensioning a chainsaw chain is essential for maintaining the safety and efficiency of your chainsaw. Following these simple steps, you can quickly tighten your chainsaw chain and ensure it works at its best. Always follow safety precautions and take good care of your chainsaw to ensure it lasts a long time.